Is My Well Pressure Tank Not Working Properly?

September 28, 2020 10:40 pm Published by Leave your thoughts

When you have a water well installed in your home in rural North Carolina, you might operate under the assumption that you’re essentially getting a deep hole in the ground and not much else. In fact, your water well is a complicated set of interlocking parts, one of the most important of which is your pressure tank.

In a home with a well, the water pump is primarily responsible for forcing air from the well and into the home’s fixtures. However, when a pump is forced to turn on and off repeatedly, it will wear down much more rapidly. The well pressure tank in Monroe, NC takes some of the stress off the pump by acting as something of an intermediary. When the pump turns on, it will supply enough water to fill the home, plus the water pressure tank. Then, the well pressure tank will store this water so it can be used as needed over the next several hours. This allows the water pump to work for a long time and then rest for an equally long time.

In the long run, a well pressure tank can be a substantial cost-saving measure for your home—provided it’s working, of course. If you’re wondering about the quality of your well pressure tank, here are some warning signs to look out for.

Know its lifespan

When it’s installed, a mid-level well pressure tank should last you around 15 years, provided the water remains clean and you have it inspected regularly. That said, when it comes to well pressure tanks, the more you invest, the longer it will last. Low-level tanks may quit after five years, while tanks of the highest quality can last up to 30 years. If your tank is reaching the end of its lifespan, keep an eye out for the following issues.

Problems to keep an eye on

Here are some common problems that indicate a failing well pressure tank in Monroe, NC:

  • Bad water pressure: You notice the water pressure in your home is varying from moment to moment.
  • Rapidly cycling pump: Your water well pump is consistently turning on and off.
  • Cold tank: Generally, your tank should be warm to the touch. If it isn’t, your tank could be malfunctioning.

If you notice any of these issues, it’s critical to call in a qualified well contractor to investigate.

Your trusted well team

If your well pressure tank isn’t working in Monroe, NC and you’re in the market for a new one, put your trust in Love Well & Pump Supply, LLC. Since we opened in 1967, we’ve dedicated ourselves to offering the best service in rural North Carolina. We offer a wide range of services, including well inspections, abandoned well services, trenching and more. Whether your needs are residential, agricultural or light commercial, or you’re planning to irrigate your nursery or greenhouse, you can count on Love Well & Pump Supply, LLC to provide top-notch service at a competitive price. Pick up the phone and give us a call today to schedule an appointment. We can’t wait to hear from you.

Categorised in:

This post was written by Writer

No Comments

Leave a Reply

Your email address will not be published. Required fields are marked *